LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1957 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  3. Remove the EOP  switch.
    • To install, tighten to 18 Nm (159 lb-in).
  4. To install, reverse the removal procedure.
    • Apply thread sealant with PTFE to the EOP  switch threads prior to installation.
scientia non olet · About LEMON Manuals