LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1955 (Body System - Full Frame & Body Mounting System) >> General Procedures >> Frame Drilling

Frame Drilling

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. If a hole must be drilled in the frame, make sure the hole meets the following requirements:
    • The hole is at least the specified distance from the edge of the nearest hole.
    • The edge of the drilled hole is at least the specified distance from the edge of the flange.
    • The hole is at least the specified distance above the frame centerline.
    • The drilled hole is at least the specified distance from any other existing bracket or component of the frame.
    2. Fig 1: Drilling Frame
    GF0013526Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals