LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1949 (Safety Belt System) >> General Procedures >> Safety Belt Tongue Rotated on Belt

Safety Belt Tongue Rotated on Belt

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Grasp the belt tongue and pull the belt webbing down to form a loop through the upper (longer and narrower) slot in the tongue.
    2. Fig 1: Forming A Belt Webbing Loop Through Slot In Tongue
    GF0000113Courtesy of FORD MOTOR CO.
  2. Rotate and fold the belt webbing over itself within the slot to remove the twist.
  3. Pull the excess belt webbing back through the upper slot in the belt tongue.
  4. Grasp the belt tongue and pull the belt webbing up to form a loop through the lower slot in the tongue.
  5. Rotate and fold the belt webbing over itself within the slot to remove the twist.
    6. Fig 2: Rotating And Folding Belt Webbing Over Itself
    GF0000114Courtesy of FORD MOTOR CO.
  6. Pull the excess belt webbing through the slot.
scientia non olet · About LEMON Manuals