Electronic Pressure Control (EPC) Solenoid: Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Install the EPC solenoid.
- Install the EPC solenoid.
- Install the EPC solenoid bracket and bolt.
- Tighten to 10 Nm (89 lb-in).
- Inspect the molded lead frame for damage.
- Using the special tool, check all molded lead frame solenoid connections. The gauge should fit tightly and not fall out after being inserted.
- If the special tool passes through any molded lead frame connector pins or does not feel like it makes a good contact, install a new molded lead frame.
- Connect the molded lead frame to the solenoids.
- Connect the bulkhead interconnector by pressing it in place by hand and fully seating the connector in place.
- Connect the EPC solenoid by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the connector slots.
- Connect the TCC by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the connector slots.
- Connect the shift solenoid SSA and SSB by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the connector slots.
- Install the manual control lever. For additional information, refer to Manual Control Lever Shaft and Seal .