LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1918 (Engine Ignition System - 4.6L (2V)) >> Removal & Installation >> Ignition Coil-On-Plug >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet pipe. For additional information, refer to REMOVAL AND INSTALLATION article.
  2. Disconnect the electrical connector from the ignition coil-on-plug.
  3. Remove the bolt from the ignition coil-on-plug.
    • To install, tighten to 6 Nm (53 lb-in).
  4. Remove the ignition coil-on-plug.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals