LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1916 (Body Panel System - Front End Body Panels) >> Removal & Installation >> Fender >> Installation

Removal & Installation: Fender: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fender.
    2. NOTE: An assistant is needed to support the fender when installing this bolt on the RH fender.
  2. Install the rear inner fender bolt.
  3. Install the 2 upper rear fender bolts.
    • Tighten to 43 Nm (32 lb-ft).
  4. Install the rear fender bolt.
    • Tighten to 28 Nm (21 lb-ft).
  5. Install the 2 rocker panel fender bolts and any required spacers.
    • Tighten to 28 Nm (21 lb-ft).
    6. NOTE: The vehicle must be at the correct ride height when the front of the fender is attached. Failure to lower the vehicle will cause a misalignment between the radiator support and the fender.
  6. Install the wheel and tire. For additional information, refer to REMOVAL & INSTALLATION article.
  7. Install the 2 upper front fender bolts.
    • Tighten to 12 Nm (106 lb-in).
  8. Install the 3 lower front fender bolts.
    • Tighten to 12 Nm (106 lb-in).
  9. Install the fender brace bolt.
    • Tighten to 12 Nm (106 lb-in).
  10. Position the rocker panel molding and install the 2 pin-type retainers.
    11. NOTE: Body grounds may vary from side-to-side.
  11. Install the ground wire bolts.
    • Tighten to 5 Nm (44 lb-in).
    12. NOTE: The wire harness trough is only located on the LH fender.
  12. Position the wiring harness trough and hood latch release cable and install the 2 screws.
  13. Install the front bumper cover. For additional information, refer to REMOVAL AND INSTALLATION article.
  14. Install the fender splash shield. For additional information, refer to Fender Splash Shield - LH  or Fender Splash Shield - RH .
    15. NOTE: Two technicians are needed to carry out this step.
  15. Position the hood and line up the hood with the marks on the hinges and install the 4 hood hinge bolts.
    • Tighten to 28 Nm (21 lb-ft).
  16. Install the cowl panel grille. For additional information, refer to Cowl Panel Grille .
scientia non olet · About LEMON Manuals