Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 12 pin-type retainers and the decklid trim panel.
- Disconnect the remote latch cable from the lock cylinder, if necessary.
- Remove the 7 reversing lamp nuts.
- Disconnect the electrical connector.
- To install, tighten to 5 Nm (44 lb-in).
- Remove the license plate.
- Remove the screw and the reversing lamp assembly.
- To install, reverse the removal procedure.