Differential Case and Ring Gear - Conventional: Disassembly

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Remove the differential assembly from the differential housing. For additional information, refer to Differential Carrier .
Remove the 10 differential ring gear bolts.

Fig 1: Differential Ring Gear Bolts

GF0013958

Courtesy of FORD MOTOR CO.

CAUTION: Do not damage the bolt hole threads.

Insert a punch in the bolt holes and drive off the differential ring gear.

Fig 2: Removing Differential Ring Gear

GF0000847

Courtesy of FORD MOTOR CO.

Using the special tools, remove the 2 differential bearings, if necessary.

Fig 3: Removing Differential Bearings Using Special Tool

G03878588

Courtesy of FORD MOTOR CO.

Remove the differential pinion shaft bolt.

Fig 4: Identifying Differential Pinion Shaft Lock Bolt

GF0000853

Courtesy of FORD MOTOR CO.

Remove the differential pinion shaft.

Fig 5: Identifying Differential Pinion Shaft

GF0000854

Courtesy of FORD MOTOR CO.

Rotate and remove the 2 differential pinion gears and 2 differential pinion thrust washers.

Fig 6: Identifying Differential Pinion Gears & Differential Pinion Gear Thrust Washers

GF0000855

Courtesy of FORD MOTOR CO.

Remove the 2 differential side gears and 2 differential side gear thrust washers.

Fig 7: Identifying Differential Side Gears & Differential Side Gear Thrust Washers

GF0000856

Courtesy of FORD MOTOR CO.