LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1869 (Cruise Control System) >> Removal And Installation >> Cruise Control Deactivator Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the electrical connector.
  2. Rotate the cruise control deactivator switch counterclockwise one-quarter turn.
  3. Remove the cruise control deactivator switch.
    4. NOTE: When installing the cruise control deactivator switch, it is automatically self-adjusting to the correct position. Do not pull up or push down on the pedal during installation. Initial installation of the cruise control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new switch.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals