LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1845 (Engine Cooling System - (Except Hybrid)) >> Removal And Installation >> Thermostat Housing - 2.5L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Disconnect the heater hose from the thermostat housing.
  3. Disconnect the lower radiator hose from the thermostat housing.
    4. NOTE: The view of the thermostat housing bolts is obstructed by A/C and other engine components. However, the bolts can be removed by using 1/4-in drive hand tools.
  4. Remove the 3 bolts and thermostat housing.
    • Remove and discard the gasket.
    • To install, tighten the bolts to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
    • Install a new gasket.
  6. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals