Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The subwoofer speaker, amplifier, and enclosure and only replaced as a complete assembly.
- Remove the RH quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the subwoofer amplifier electrical connector.
- Remove the 3 bolts and the subwoofer speaker.
- To install, tighten to 8 Nm (71 lb-in).
- To install, reverse the removal procedure.