LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1837 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.
  2. Remove the bolt and the MAP  sensor.
    • To install, tighten to 6 Nm (53 lb-in).
    • When installing the sensor, if the bolt fails to hold specified torque, relocate the sensor and retain, using the auxiliary bolt hole in the upper intake manifold.
    3. NOTE: Clean and inspect the sealing surface.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals