LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1837 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Installation

Knock Sensor (KS): Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Engine block-mounted KS 

  1. Install the KS  and the bolt.
    • Tighten to 25 Nm (18 lb-ft).
  2. Connect the KS  electrical connector.
  3. Install the lower intake manifold. For additional information, refer to LOWER INTAKE MANIFOLD .

    Cylinder head-mounted KS 

  4. Install the KS  and the bolt.
    • Tighten to 25 Nm (18 lb-ft).
  5. Connect the KS  electrical connector.
scientia non olet · About LEMON Manuals