LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1835 (Engine Controls - Electronic Engine Controls - 2.5L (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
  2. Detach the wiring harness retainer from the cowl stud bolt.
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the 2 bolts and the PCM.
  5. Remove and inspect the PCM cowl seal. Install new if damaged.
scientia non olet · About LEMON Manuals