LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1835 (Engine Controls - Electronic Engine Controls - 2.5L (Hybrid)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the Cylinder Head Temperature (CHT) sensor cover and position aside.
  2. Disconnect the CHT  sensor electrical connector.
  3. Remove the CHT  sensor.
    • To install, tighten to 12 Nm (106 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals