LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1835 (Engine Controls - Electronic Engine Controls - 2.5L (Hybrid)) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Camshaft Position (CMP) sensor electrical connector.
  2. Remove the bolt and the CMP  sensor.
    • To install, tighten to 7 Nm (62 lb-in).
    • Inspect the O-ring seal and install new as necessary.
    3. NOTE: Lubricate the CMP  sensor O-ring seal with clean engine oil.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals