Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.
- Depower the Supplemental Restraint System (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
- Remove the steering column opening trim.
- Remove the 3 lower steering column shroud screws.
- Remove the upper and lower steering column shrouds.
- Disconnect the ignition switch electrical connector.
- Remove the ignition switch by pressing the 2 tabs and pulling the ignition switch outward.
- To install, reverse the removal procedure.
- Repower the SRS . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .