Pinpoint Test C: The Windshield Wipers Stay On Continuously: Testing
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- C1 CHECK THE WIPER SWITCH
- Disconnect: Wiper Switch C202a.
Carry out the wiper switch component test. Refer to COMPONENT TESTING .
- Did the wiper switch pass the component test?
- Yes : GO to C2.
- No : INSTALL a new wiper switch. REFER to STEERING COLUMN SWITCHES .
- Disconnect: Wiper Switch C202a.
- C2 CHECK WIPER SWITCH CIRCUIT 1205 (BK) FOR OPEN
- Measure the resistance between wiper switch C202a-2, circuit 1205 (BK), harness side and ground.
- Is the resistance less than 5 ohms?
- Yes : GO to C3.
- No : REPAIR the circuit. TEST the system for normal operation.
- C3 CHECK CIRCUITS 61 (YE/RD), 63 (RD), 950 (WH/BK), AND 58 (WH) FOR SHORTS
- Disconnect: Windshield Wiper Motor C125.
- Using the following table, measure the resistance between the windshield wiper motor harness side and ground:WINDSHIELD WIPER MOTOR C125 CONNECTOR-PIN REFERENCE
Windshield Wiper Motor C125 Ground C125-10, circuit 61 (YE/RD) ground C125-11, circuit 63 (RD) ground C125-12, circuit 950 (WH/BK) ground C125-1, circuit 58 (WH) ground - Is the resistance greater than 10,000 ohms for each circuit?
- Yes : GO to C4.
- No : REPAIR the circuit(s). TEST the system for normal operation.
- C4 CHECK FOR CORRECT WIPER MOTOR OPERATION
- Disconnect the windshield wiper motor connector.
- Check for:
- corrosion
- pushed-out pins
- Connect the windshield wiper motor connectors and make sure they are seated correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?
- Yes : INSTALL a new windshield wiper motor. REFER to WINDSHIELD WIPER MOTOR . TEST the system for normal operation.
- No : The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. TEST the system for normal operation.