LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1778 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Installation

Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new O-ring seal on the oil pump screen and pickup tube.
    • Lubricate the O-ring seal with clean engine oil.
  2. Install the oil pump screen and pickup tube.
    1. Position the oil pump screen and pickup tube.
    2. Install the bolts and tighten to 10 Nm (89 lb-in).
      Fig 1: Identifying Oil Pump Screen And Pickup Tube Bolt
      G06389385Courtesy of FORD MOTOR CO.
  3. Install the oil pan. For additional information, refer to OIL PAN .
scientia non olet · About LEMON Manuals