Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the PAM
configuration information to the scan tool. For additional information, Refer to PROGRAMMABLE MODULE INSTALLATION (PMI)
.NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.
- Remove the LH rear seat bolster. For additional information, Refer to REMOVAL .
- Remove the 2 screws and the PAM
.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
- Download the PAM configuration information. For additional information, Refer to MODULE CONFIGURATION .