LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1725 (Manual Transaxle) >> In-Vehicle Repair >> Halfshaft Seal >> Installation

Halfshaft Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Halfshaft Oil Seal Installer, install the RH intermediate shaft or the LH halfshaft oil seal.
    Fig 1: Identifying Halfshaft Oil Seal Installer
    G06275881Courtesy of FORD MOTOR CO.
  2. Install the RH intermediate shaft or LH halfshaft. For additional information, refer to INSTALLATION .
    NOTE: Do not allow the splines on the halfshaft to touch the oil seal.
  3. Fill the transaxle to specification. For additional information, refer to TRANSAXLE DRAINING AND FILLING .
scientia non olet · About LEMON Manuals