LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1724 (Automatic Transaxle External Controls (Hybrid)) >> Removal And Installation >> Selector Lever >> Installation

Selector Lever: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the selector lever and the 4 nuts.
    • Tighten to 20 Nm (177 lb-in).
    Fig 1: Locating Selector Lever Nuts
    G06275784Courtesy of FORD MOTOR CO.
  2. Connect the electrical connector.
    Fig 2: Locating Electrical Connector
    G06275783Courtesy of FORD MOTOR CO.
  3. Install the selector lever cable in the selector lever housing.
    NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
    Fig 3: Identifying Selector Lever Cable In Selector Lever Housing
    G06275675Courtesy of FORD MOTOR CO.
  4. Connect the selector lever cable end to the selector lever.
    Fig 4: Identifying Selector Lever Cable Lever
    G06275674Courtesy of FORD MOTOR CO.
  5. Install the center console. For additional information, refer to REMOVAL AND INSTALLATION .
  6. Adjust the selector lever cable. For additional information, refer to SELECTOR LEVER CABLE ADJUSTMENT .
scientia non olet · About LEMON Manuals