Selector Lever Bezel: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the selector lever trim ring.

Fig 1: Locating Selector Lever Trim Ring
Courtesy of FORD MOTOR CO.
Remove the center console trim panel.

Fig 2: Center Console Trim Panel
Courtesy of FORD MOTOR CO.
Remove the utility tray from the center console.

Fig 3: Identifying Utility Tray
Courtesy of FORD MOTOR CO.
Disconnect the electrical connector and remove the utility tray.

Fig 4: Locating Electrical Connector
Courtesy of FORD MOTOR CO.
Slide the selector lever knob bezel downward to gain access to the 2 selector lever knob screws.

Fig 5: Sliding Selector Lever Knob Bezel Downward
Courtesy of FORD MOTOR CO.
Remove the 2 screws from the selector lever knob. Remove the selector lever knob and the selector lever knob bezel.

Fig 6: Identifying Selector Lever Knob & Selector Lever Knob Bezel
Courtesy of FORD MOTOR CO.
Disconnect the selector lever bezel electrical connector.

Fig 7: Locating Selector Lever Bezel Electrical Connector
Courtesy of FORD MOTOR CO.
Release the 3 tabs and remove the selector lever knob bezel.
NOTE: Selector lever removed for clarity.

Fig 8: Locating Selector Lever Knob Bezel With Tabs
Courtesy of FORD MOTOR CO.