Selector Lever - MKZ: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install the selector lever cable in the selector lever and position the selector lever on the studs.

Fig 1: Positioning Selector Lever On Studs
Courtesy of FORD MOTOR CO.
Install the 4 selector lever nuts.
- Tighten to 20 Nm (177 lb-in).
Fig 2: Locating Selector Lever Nuts
Courtesy of FORD MOTOR CO.
Connect the selector lever electrical connector.

Fig 3: Locating Selector Lever Electrical Connector
Courtesy of FORD MOTOR CO.
Connect the selector lever cable end on the selector lever ball stud.

Fig 4: Identifying Selector Lever Cable End On Selector Lever Ball Stud
Courtesy of FORD MOTOR CO.
Install the LH and RH center console-to-selector lever screws.
NOTE: LH shown in illustration, RH similar.

Fig 5: Locating Center Console-To-Selector Lever Screws
Courtesy of FORD MOTOR CO.
Install the LH and RH center console trim covers.
NOTE: LH shown in illustration, RH similar.

Fig 6: Locating Center Console Trim Cover
Courtesy of FORD MOTOR CO.
Install the PRNDL electrical connector on the RH side of the center console.

Fig 7: Locating PRNDL Electrical Connector
Courtesy of FORD MOTOR CO.
Install the selector lever bezel. For additional information, refer to Installation .
Check the selector lever cable adjustment. Make sure that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. If an adjustment is necessary, refer to SELECTOR LEVER CABLE ADJUSTMENT - AISIN AW21 .