LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1720 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch Release Handle - Secondary >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 radiator grille pin-type retainers and the 4 radiator grille bolts.
  2. Disconnect the secondary hood latch release cable from the hood latch.
    NOTE: Pull up on the radiator grille to gain access to the hood latch.
  3. Remove the secondary hood latch release handle bolt.
    • To install, tighten to 12 Nm (106 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals