LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1717 (HVAC - Climate Control System) >> Removal And Installation >> In-Vehicle Temperature Sensor - Fusion, Milan >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster finish panel. For additional information, refer to REMOVAL AND INSTALLATION (Fusion, Milan) and REMOVAL AND INSTALLATION (MKZ) .
  2. Disconnect the in-vehicle temperature sensor aspirator hose connection at the heater core and evaporator core housing.
  3. Detach the in-vehicle temperature sensor aspirator hose pin-type retainer.
  4. Disconnect the in-vehicle temperature sensor electrical connector.
  5. Remove the in-vehicle temperature sensor and aspirator hose assembly.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals