LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1711 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  3. Remove the bolt and the CKP 
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect the O-ring seal and install new as necessary.
  4. To install, reverse the removal procedure.
    NOTE: Lubricate the CKP  O-ring seal with clean engine oil.
  5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals