LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (Electronic Engine Controls (Hybrid)) >> Removal And Installation >> Knock Sensor (KS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the intake manifold. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the bolt and the Knock Sensor (KS).
    • To install, tighten to 20 Nm (177 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals