LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1708 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Cowl Panel Grille >> Upper cowl panel grille

Upper cowl panel grille

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 wiper pivot arms nuts.
    • To install, tighten to 20 Nm (177 lb-in).
  2. Remove the LH and RH wiper pivot arms.
  3. Remove the 2 pin-type retainers from the upper cowl panel grille.
  4. Remove the 2 bolts from the upper cowl panel grille.
  5. Remove the 2 retaining clips and the upper cowl panel grille.

    3.5L only 

  6. Insert a flat-blade screwdriver behind the power steering reservoir.
    Fig 1: Inserting Flat-Blade Screwdriver Behind Power Steering Reservoir
    G06271381Courtesy of FORD MOTOR CO.
  7. Push the retainer rearward to remove the power steering reservoir. Position the reservoir aside.
    Fig 2: Pushing Retainer Rearward
    G06271382Courtesy of FORD MOTOR CO.
  8. Remove the 2 brake fluid reservoir nuts and position the reservoir aside.
    Fig 3: Locating Brake Fluid Reservoir Nuts
    G06271383Courtesy of FORD MOTOR CO.

    Lower cowl panel grille 

  9. Remove the wiper mounting arm and wiper pivot shaft assembly in the following sequence.
    1. Disconnect the electrical connector.
    2. Remove the 2 bolts.
      • To install, tighten to 5 Nm (44 lb-in).
  10. Remove the 3 bolts and the lower cowl panel center brace.
  11. Remove the 10 lower cowl panel grille bolts.
  12. Remove the lower cowl panel grille.
  13. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals