LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1702 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Removal

Rear Disc Brake: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to REMOVAL .
  2. Disconnect the parking brake cable from the brake caliper.
    • Pull back the parking brake lever.
    • Disconnect the cable from the parking brake lever.
    • Remove the cable conduit retaining clip.
    • Disconnect the cable from the brake caliper.
  3. Remove the 2 brake caliper anchor plate bolts and position the brake caliper, brake pads and brake caliper anchor plate aside as an assembly.
    NOTE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
    • Support the brake caliper, brake pads and brake caliper anchor plate assembly using mechanic's wire.
  4. Remove the 2 brake disc screws and the brake disc.
scientia non olet · About LEMON Manuals