LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1665 (Electronically Controlled Continuously Variable Transmission (ECVT)) >> In-Vehicle Repair >> Differential Seals - RH >> Removal

Differential Seals - RH: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Turn the ignition to the OFF position.
  3. Remove the 7 screws and the underbody cover.
    Fig 1: Locating Underbody Cover Screws
    G06257240Courtesy of FORD MOTOR CO.
  4. Remove the drain plug and drain the transmission fluid.
    Fig 2: Locating Drain Plug
    G06275478Courtesy of FORD MOTOR CO.
  5. Remove the intermediate shaft. For additional information, refer to REMOVAL (FWD) and/or REMOVAL (AWD) .
  6. Using the Slide Hammer and RH Halfshaft Fluid Seal Remover, remove and discard the RH differential seal.
    Fig 3: Identifying Slide Hammer & RH Halfshaft Fluid Seal Remover
    G06275497Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals