Differential Seals - LH: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The use of any transmission fluid other than what is recommended for this transaxle will cause transaxle damage.

Remove the LH halfshaft. For additional information, refer to REMOVAL .
Using a suitable awl, poke a small hole in the seal.
NOTE: Be careful not to damage the case while removing the seal.

Fig 1: Poking Small Hole In Seal
Courtesy of FORD MOTOR CO.
Using a suitable dent puller, remove the LH differential fluid seal.

Fig 2: Locating LH Differential Fluid Seal
Courtesy of FORD MOTOR CO.