LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve stem seal installation sleeve.
    Fig 1: Identifying Valve Stem Seal Installation Sleeve
    G06094982Courtesy of FORD MOTOR CO.
  2. Using the Valve Stem Oil Seal Installer, install the valve seal.
    Fig 2: Identifying Valve Seal
    G06094983Courtesy of FORD MOTOR CO.
  3. Using the Valve Spring Compressors, install the valve spring.
    • Insert the valve spring and the valve spring retainer.
    • Compress the valve spring and install the valve collet using some grease and a small screwdriver.
    NOTE: Check the seating of the valve collet.
    Fig 3: Identifying Valve Spring And Valve Spring Retainer Special Tools
    G06094972Courtesy of FORD MOTOR CO.
  4. Disconnect the compressed air supply.
  5. Install the spark plugs. For additional information, refer to REMOVAL AND INSTALLATION .
  6. Repeat the appropriate removal and installation steps for all of the other cylinders.
  7. Coat the valve tappets with clean engine oil and insert them.
  8. Install the camshafts. For additional information, refer to Installation .
scientia non olet · About LEMON Manuals