Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.

Install the valve tappets.
NOTE: The valve tappets must be installed in their original positions.

NOTE: Coat the valve tappets with clean engine oil prior to installation.

Fig 1: Locating Valve Tappets
Courtesy of FORD MOTOR CO.
Depending on the valve tappets being serviced, install the LH and/or the RH camshafts. For additional information, refer to Removal and Installation .