LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1660 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the oil level indicator.
  3. If equipped, disconnect the block heater electrical connector and wiring harness retainers.
  4. Remove the stud bolt and the oil level indicator tube.
    • Discard the O-ring seal.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
    NOTE: Install a new O-ring seal and lubricate with clean engine oil.
scientia non olet · About LEMON Manuals