LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1660 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the accessory drive belt. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the crankshaft pulley bolt and washer.
    • Discard the crankshaft pulley bolt.
  4. Using the 3 Jaw Puller, remove the crankshaft pulley.
    Fig 1: Identifying 3-Jaw Puller (303-D121) On Crankshaft Pulley
    G06095503Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals