LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1659 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the engine in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine front cover. For additional information, refer to Removal .
  3. Drain the engine oil, then install the drain plug.
    • To install, tighten to 28 Nm (21 lb-ft).
  4. Remove the 3 oil pan-to-bellhousing bolts.
  5. Remove the 13 bolts and the oil pan.
  6. Remove the 2 bolts and the oil pump screen and pickup tube.
    • To install, tighten to 10 Nm (89 lb-in).
    NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
  7. Remove the oil pump drive chain tensioner.
    1. Release the tension on the tensioner spring.
    2. Remove the tensioner and the 2 shoulder bolts.
    Fig 1: Identifying Tensioner Spring & Shoulder Bolts
    G06261955Courtesy of FORD MOTOR CO.
  8. Remove the chain from the oil pump sprocket.
  9. Remove the bolt and oil pump sprocket.
  10. Remove the 4 bolts and the oil pump.
scientia non olet · About LEMON Manuals