DTC P050B: Cold Start Ignition Timing Performance
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P050B: COLD START IGNITION TIMING PERFORMANCE
| Description: | The monitor compares commanded spark timing to the spark timing desired by the powertrain control module (PCM). When the difference between desired and commanded spark timing exceeds the calibrated threshold, the DTC sets. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Disregard the freeze frame data. Freeze frame data does not apply to the cold start monitor. This DTC is informational only and may be accompanied by other DTCs. Diagnose other DTCs first. If no other DTCs are present, inspect the intake air system for air restrictions, vacuum leaks, and damage. If no concerns are present, clear the DTCs and verify the engine coolant temperature (ECT) is below 37.8° C (100°F). Allow the vehicle to soak for 2-3 hours if necessary for the ECT to fall below 37.8° C (100°F). Start the engine without touching the accelerator pedal and allow the engine to idle for 6 minutes in park. If no DTCs are present and the malfunction indicator lamp (MIL) is not illuminated after idling for 6 minutes, carry out the key on engine running KOER self-test to confirm that no DTCs are present and the repair is complete. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the appropriate DTC. | ||