LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1656 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> DTC P0219: Engine Over Speed Condition

DTC P0219: Engine Over Speed Condition

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0219: ENGINE OVER SPEED CONDITION

For Vehicles With 3.5L GTDI Engine 
Description:  Indicates the vehicle has been operated in a manner which caused the engine speed to exceed a calibrated limit. The engine RPM is continuously monitored and evaluated by the powertrain control module (PCM). The DTC sets when the RPM exceeds the calibrated limit set within the PCM. For additional information on the engine RPM limiter, refer to POWERTRAIN CONTROL SOFTWARE .
Possible Causes: 
  • Wheel slippage (water, ice, mud, and snow)
  • Excessive engine RPM in NEUTRAL or operated in the incorrect transmission gear
  • High engine RPM with engine temperature within a calibrated limit of an overheating condition
Diagnostic Aids:  This DTC may be accompanied by other DTCs. If DTCs P1285 or P1299 are present, disregard DTC P0219 at this time. Diagnose DTCs P1285 or P1299 first.
The DTC indicates the vehicle has been operated in a manner which caused the engine speed to exceed a calibrated limit.
If excessive engine RPM is suspected, refer to POWERTRAIN CONTROL SOFTWARE , Engine Fluid Temperature Management, for additional information.
For All Others 
Description:  Indicates the vehicle has been operated in a manner which caused the engine speed to exceed a calibrated limit. The engine RPM is continuously monitored and evaluated by the powertrain control module (PCM). The DTC sets when the RPM exceeds the calibrated limit set within the PCM.
For additional information on the engine RPM limiter, refer to POWERTRAIN CONTROL SOFTWARE .
Possible Causes: 
  • Wheel slippage (water, ice, mud, and snow)
  • Excessive engine RPM in NEUTRAL or operated in the incorrect transmission gear
Diagnostic Aids:  This DTC may be accompanied by other DTCs. If DTCs P1285 or P1299 are present, disregard DTC P0219 at this time. Diagnose DTCs P1285 or P1299 first.
The DTC indicates the vehicle has been operated in a manner which caused the engine speed to exceed a calibrated limit.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All - - GO to PINPOINT TEST ND .
scientia non olet · About LEMON Manuals