Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the wheel speed sensor electrical connector.
- Remove the 2 wheel speed sensor harness retainers.
- Remove the wheel speed sensor bolt.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the wheel speed sensor.
- To install, reverse the removal procedure.