Encoded PATS Keys

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A maximum of 8 PATS keys can be programmed into the IC.

NOTE: A minimum of 2 keys must be programmed into the IC before the vehicle will start.

PATS uses a special ignition key, called an integrated keyhead transmitter (IKT) key that is larger than a conventional ignition key. It contains a permanently installed electronic device called a transponder and also has the remote keyless entry (RKE) transmitter integrated into the keyhead. Each transponder contains a unique encrypted identification code which is one of a very large number of combinations. The addition of this transponder to the key makes it an "encoded" key. The PATS key does not require batteries and should last the lifetime of the vehicle. The transmitter portion of the IKT key has a battery. Each PATS key must be programmed into the IC before it can be used to start the vehicle. A maximum of 4 IKT keys can be programmed to start the vehicle and also operate the RKE functions. If more than 4 IKT keys are programmed, the RKE portion of the additional IKT keys does not operate and the SJB sets a memory full DTC (B1138 - Memory Full). The same DTC (B1138 - Memory Full) will also be flagged in the IC. The memory that is full is referring to the memory in the SJB. These additional keys (more than 4 IKTs) will start the vehicle, but will not operate the RKE system. If additional PATS keys are desired, a standard PATS key (a non-IKT key) can be used. There are special diagnostic procedures described in this service information that must be carried out if a new PATS key is necessary. Refer to Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment or Key Programming Using Two Programmed Keys .