Subframe Bushings - Rear Differential, Front: Removal

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: There are 2 rear drive unit (RDU) front bushings in the rear subframe, this procedure shows how to remove one bushing. The procedure for the remaining RDU bushing is identical.

Remove the rear drive unit. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL article.

NOTE: Make sure the 204-618/2 is positioned with the larger opening toward the bushing to act as the receiver cup.

NOTE: Make sure the arrow on the special tool is pointed toward the rear subframe when removing the bushing.

Assemble the special tools to the rear subframe and press out the bushing.

Fig 1: Identifying Special Tools

Courtesy of FORD MOTOR CO.