LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1620 (Handles, Locks, Latches & Entry Systems) >> General Procedures >> Keyless Entry Keypad Code Programming >> Programming a Personal Entry Code and Keypad Association to Memory Seats and Mirrors (If Equipped)

Programming a Personal Entry Code and Keypad Association to Memory Seats and Mirrors (If Equipped)

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The system allows 3 personal codes to be programmed.
  1. Enter the factory set 5-digit keyless entry keypad code.
  2. Within 5 seconds, press the 1/2 button on the keypad to activate the programming mode.
  3. Enter the new 5-digit keyless entry keypad code. Each number must be entered within 5 seconds of each other.
    4. NOTE: The factory-set code cannot be associated with a memory setting.
  4. To associate the entry code with a new memory setting, enter a sixth digit to indicate which driver should be set in a memory recalled by the personal entry code:
    • Pressing 1/2 recalls Driver 1 settings.
    • Pressing 3/4 recalls Driver 2 settings.
    • Pressing other keypad buttons or not pressing a keypad button as a sixth digit does not set a driver and will not recall a memory setting.
  5. The door locks will lock and unlock to confirm the new code is programmed.
scientia non olet · About LEMON Manuals