Programming the Autolock Feature Using the Instrument Cluster Message Center
WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The autolock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE:
The autolock feature of the SJB can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to MODULE CONFIGURATION
article.
- With all the vehicle doors closed, turn the ignition key from the OFF to the ON position.
- Press the SETUP button on the message center switch until AUTOLOCK <ON> OFF is displayed.
- Press the RESET button to select ON or OFF. If the autolocks are enabled, the message center will have brackets around the <ON> display. If the autolocks are disabled, the message center will have brackets around the <OFF> display.