Programming the Auto-Unlock Feature Using the Keyless Entry Keypad
WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE:
The auto-unlock feature of the SJB can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to MODULE CONFIGURATION
article.
- Turn the ignition key to the OFF position and close all vehicle doors.
- Enter the factory set 5-digit keyless entry keypad code.
- Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release the 7/8 button a second time.
- Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.