Lower Intake Manifold: Installation

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Using new intake manifold and thermostat housing gaskets, install the lower intake manifold and the 10 bolts.
- Tighten in the sequence shown in illustration in sequence to 10 Nm (89 lb-in).

Fig 1: Installing Lower Intake Manifold Bolts In Sequence

Courtesy of FORD MOTOR CO.

Install the 3 thermostat housing-to-lower intake manifold bolts.
- Tighten to 10 Nm (89 lb-in).
Install the fuel rail. For additional information, refer to FUEL CHARGING AND CONTROLS - 3.5L article.
Fill and bleed the cooling system. For additional information, refer to ENGINE COOLING article.