Cylinder Head: Assembly

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

All cylinder heads

NOTE: Lubricate the valve stem seal with clean engine oil prior to installation.

Using the Valve Stem Oil Seal Installer, install a new valve stem seal.

Fig 1: Installing New Valve Stem Seal Using Special Tool (303-470)

Courtesy of FORD MOTOR CO.

Install the valve.
Using the Valve Spring Compressors, install the valve spring, retainer and key.

Fig 2: Removing Keys, Retainer & Spring Using Special Tools (303-1249, 303-350, 303-300)

Courtesy of FORD MOTOR CO.

Repeat the above steps for each valve.

RH cylinder head

Install a new CHT sensor.
- Tighten to 10 Nm (89 lb-in).