Second Row Power-Fold Seat (Taurus X)

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The smart junction box (SJB) may also be identified as generic electronic module (GEM).

For the second row power-fold seat to operate, voltage is supplied by the SJB to the power-fold seat relay, enabling the seats to then be moved by pressing the second row power-fold seat switch.

The power-fold seat relay will be provided voltage on the coil side from the SJB for 30 minutes when the transmission selector is in PARK, and the liftgate, or liftgate glass, is open. The voltage will be disabled 30 minutes after turning the vehicle OFF. If the relay is disabled after 30 minutes, it can be enabled by opening any door, pressing the unlock key on the key fob, pressing any keyless keypad button or turning the ignition key.

The second row power-fold seat motor retracts a cable to release the backrest recliner latches and allows the backrest assist spring to fold the backrest forward onto the seat cushion. The power-fold seat motor continues to retract to release the seat-to floor latches and allows the spring assist strut to lift and tumble the seat forward to the E-Z entry position for 3rd row seat access. Immediately after the seat is fully released, the power-fold seat motor returns the release cable and latches to a relaxed state, ready for manual latching. To return to a seating position, the seat must be manually latched to the floor and the backrest must be manually latched upright.