LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    2. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
  2. Remove the brake caliper anchor plate bolts and discard. Position the brake caliper anchor plate aside.
    • To install, tighten to 110 Nm (81 lb-ft).
  3. Remove and discard the brake disc screw.
    • To install, tighten to 21 Nm (15 lb-ft).
  4. Remove the brake disc.
  5. To install, reverse the removal procedure, using 2 new brake caliper anchor plate bolts.
scientia non olet · About LEMON Manuals