LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1595 (Power Steering System) >> Removal And Installation >> Power Steering Control Valve Actuator >> Removal

Power Steering Control Valve Actuator: Removal

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.
  1. Using a suitable suction device, siphon the power steering fluid from the power steering reservoir.
  2. Remove the 7 pin-type retainers and the RH splash shield.
    3. Fig 1: Identifying Pin-Type Retainers
    GF0045923Courtesy of FORD MOTOR CO.
  3. Using the Power Steering Belt Removal Tool, remove the power steering pump belt from the power steering pump pulley and position it aside.
    • Install the Power Steering Belt Removal Tool between the power steering pump belt and pulley and turn the crankshaft bolt clockwise.
    4. Fig 2: Installing Special Tool (303-1252/1) Between Power Steering Pump Belt & Pulley, Turning Crankshaft Bolt Clockwise
    GF0031434Courtesy of FORD MOTOR CO.
  4. Disconnect the power steering control valve actuator electrical connector.
  5. Remove the 3 power steering pump bolts.
  6. Holding the power steering pump with a suitable holding device, loosen the bolt and remove the power steering control valve actuator.
scientia non olet · About LEMON Manuals